VOLTCRAFT IR 1200-50D Instrucciones de operaciones descargar pdf (Pagina 43)



Setting emission degree according to the table

The emission degree can be set via an integrated material table for common metals.

Select the function “Tab” via the button “F2”. A materials table is displayed.

Use the function buttons “F1” and “F3” to set the present material. The selected material is marked with a bar. The

degree of emission changes accordingly.

“Default” = Emission value of most materials (0.95)

“Ox Aluminum” = Aluminium, oxidised (0.30)

“Ox Brass” = Brass, oxidised (0.50)

“Ox Copper” = Copper, oxidised (0.60)

“Paint” = Painted surface (0.93)

Conrm the selection with “OK” (button “F2”). To terminate the setting, push the measuring button (5) or the button

“MODE”.

 Below the technical data, you will nd a table with typical materials and their emission degrees.

Many organic materials have an emission degree of 0.95. Therefore, the factory setting of the emission degree

is 0.95.



The meter is equipped with a continuous measurement function for long-term measurements.

Switch on the meter by briey pushing the measuring button (5).

Select the setting menu by pushing the button “MODE” within the pre-set deactivation time

The continuous measurement is switched on and off via the function button “F1”. Every push will switch the function

on or off.

Continuous measurement off

Continuous measurement on

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 101 102

Sin comentarios

VOLTCRAFT IR 1200-50D Instrucciones de operaciones Pagina 43